Netgear GSM7252PS ProSafe Managed Switch Web Management User Manual - Page 221
Routing Mode, ICMP Echo Replies, ICMP Redirects, ICMP Rate Limit, ICMP Rate Limit Burst Size
UPC - 606449071665
View all Netgear GSM7252PS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 221 highlights
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual 1. Use Routing Mode to select enable or disable. You must enable routing for the switch before you can route through any of the interfaces. The default value is disable. 2. Use ICMP Echo Replies to select enable or disable. If it is enable, then only the router can send ECHO replies. By default ICMP Echo Replies are sent for echo requests. 3. Use ICMP Redirects to select enable or disable. If it is enabled globally and on interface level then only the router can send ICMP Redirects. 4. Use ICMP Rate Limit Interval to control the ICMP error packets by specifying the number of ICMP error packets that are allowed per burst interval. By Default Rate limit is 100 packets/sec, i.e., burst interval is 1000 msec. To disable ICMP Ratelimiting set this field to '0'.Valid Rate Interval must be in the range 0 to 2147483647. 5. Use ICMP Rate Limit Burst Size to control the ICMP error packets by specifying the number of ICMP error packets that are allowed per burst interval. By Default burst size is 100 packets. When burst interval is 0 then configuring this field is not a valid operation. Valid Burst Size must be in the range 1 to 200. Table 9. Field Default Time to Live Maximum Next Hops Description The default value inserted into the Time-To-Live field of the IP header of datagrams originated by the switch, if a TTL value is not supplied by the transport layer protocol. The maximum number of hops supported by the switch. This is a compile-time constant. Chapter 4. Routing | 221