Netgear GSM7252PS ProSafe Managed Switch Web Management User Manual - Page 93

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual Table 5. Field Status Fault Status Definition Operational status of the port PD detection. • Disabled - indicates no power being delivered. • DeliveringPower - indicates power is being drawn by device. • Fault - indicates a problem with the port. • Test - indicates port is in test mode. • otherFault - indicates port is idle due to error condition. • Searching - indicates port is not in one of the above states. Describes the error description when the PSE port is in fault status. "No Error" value specifies that the PSE port is not in any error state. "MPS Absent" value specifies that the PSE port has detected an absence of main power supply. "Short" value specifies that the PSE port has detected a short circuit condition. "Overload" value specifies that the pd connected to the PSE port had tried to provide more power than it is permissible by the hardware. "Power Denied" value specifies that the PSE port has been denied power because of shortage of power or due to administrative action. SNMP From SNMP link under the System tab, you can configure SNMP settings for SNMP V1/V2 and SNMPv3. From the SNMP link, you can access the following pages: • SNMPV1/V2 on page 93 • SNMP V3 on page 101 SNMPV1/V2 The pages under the SNMPV1/V2 menu allow you to configure SNMP community information, traps, and trap flags. From the SNMP V1/V2 link, you can access the following pages: • Community Configuration on page 94 • Trap Configuration on page 96 • Trap Flags on page 97 • Supported MIBs on page 99 Chapter 2. Configuring System Information | 93