Netgear GSM7252PS ProSafe Managed Switch Web Management User Manual - Page 258
RIP, Basic
UPC - 606449071665
View all Netgear GSM7252PS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 258 highlights
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual • None - Selected if the user does not want to delete any entry from the ARP Table. 7. Use Remove IP Address to enter the IP Address against the entry that is to be removed from the ARP Table. This appears only if the user selects Specific Dynamic/Gateway Entry or Specific Static Entry in the Remove from Table Drop Down List. Table 23. Field Total Entry Count Peak Total Entries Active Static Entries Configured Static Entries Maximum Static Entries Description Total number of Entries in the ARP table. Highest value reached by Total Entry Count. This counter value is restarted whenever the ARP table Cache Size value is changed. Total number of Active Static Entries in the ARP table. Total number of Configured Static Entries in the ARP table. Maximum number of Static Entries that can be defined. RIP RIP is an Interior Gateway Protocol (IGP) based on the Bellman-Ford algorithm and targeted at smaller networks (network diameter no greater than 15 hops). The routing information is propagated in RIP update packets that are sent out both periodically and in the event of a network topology change. On receipt of a RIP update, depending on whether the specified route exists or does not exist in the route table, the router may modify, delete, or add the route to its route table. From the RIP link, you can access the following pages: • Basic on page 258 • Advanced on page 260 Basic From the Basic link, you can access the following pages: • RIP Configuration on page 259 258 | Chapter 4. Routing