Netgear GSM7252PS ProSafe Managed Switch Web Management User Manual - Page 297
OSPFv3 Configuration, Routing, OSPFv3, Basic, Configuration, Admin Mode, Router ID
UPC - 606449071665
View all Netgear GSM7252PS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 297 highlights
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual OSPFv3 Configuration Use the OSPFv3 Configuration page to activate and configure OSPFv3 for a switch. To display the OSPFv3 Configuration page, click Routing OSPFv3 Basic OSPFv3 Configuration. 1. Use Admin Mode* to select enable or disable. If you select enable, OSPFv3 will be activated for the switch. The default value is disable. You must configure a Router ID before OSPFv3 can become operational. This can also be done by issuing the CLI command router-id, in the IPv6 router OSPF mode. 2. Use Router ID to specify the 32-bit integer in dotted decimal format that uniquely identifies the router within the autonomous system (AS). If you want to change the Router ID you must first disable OSPFv3. After you set the new Router ID, you must re-enable OSPFv3 to have the change take effect. The default value is 0.0.0.0, although this is not a valid Router ID. Note: *Once OSPFv3 is initialized on the router, it will remain initialized until the router is reset. Chapter 4. Routing | 297