Netgear GSM7252PS ProSafe Managed Switch Web Management User Manual - Page 263

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual RIP Interface Configuration 1. Use Interface to select the interface for which data is to be configured. 2. Use Send Version to select the version of RIP control packets the interface should send from the pull-down menu. The value is one of the following: • RIP-1 -Send RIP version 1 formatted packets via broadcast. • RIP-1c -RIP version 1 compatibility mode. Send RIP version 2 formatted packets via broadcast. • RIP-2 - Send RIP version 2 packets using multicast. The default is RIP-2. • None - No RIP control packets will be sent. 3. Use Receive Version to select what RIP control packets the interface will accept from the pull-down menu. The value is one of the following: • RIP-1 - Accept only RIP version 1 formatted packets. • RIP-2 - Accept only RIP version 2 formatted packets. The default is RIP-2. • Both - Accept packets in either format. • None - No RIP control packets will be accepted. 4. Use RIP admin mode to enable RIP for an interface. The default is Disable. 5. Use Authentication Type to select an authentication type other than none by clicking on the 'Configure Authentication' button. You will then see a new screen, where you can select the authentication type from the pull-down menu. The choices are: • None - This is the initial interface state. If you select this option from the pull-down menu on the second screen you will be returned to the first screen and no authentication protocols will be run. • Simple - If you select 'Simple' you will be prompted to enter an authentication key. This key will be included, in the clear, in the RIP header of all packets sent on the network. All routers on the network must be configured with the same key. • Encrypt - If you select 'Encrypt' you will be prompted to enter both an authentication key and an authentication ID. Encryption uses the MD5 Message-Digest algorithm. All routers on the network must be configured with the same key and ID. 6. Use Authentication Key to enter the RIP Authentication Key for the specified interface. If you do not choose to use authentication you will not be prompted to enter a key. If you choose 'simple' or 'encrypt' the key may be up to 16 octets long. The key value will only be displayed if you are logged on with Read/Write privileges. 7. Use Authentication Key ID to enter the RIP Authentication Key ID for the specified interface. If you choose not to use authentication or to use 'simple' you will not be prompted to enter the key ID. If you choose 'encrypt' the key ID may be in range from 0 to 255. The key ID value will be displayed only if you are logged on with Read/Write privileges. 8. Click CANCEL to display a new screen where you can select the authentication method for the virtual link. Chapter 4. Routing | 263