Yamaha A3000 Owner's Manual - Page 123

Chapter 4 EFFECT Function EFFECT Function This section describes the PLAY-mode EFFECT function. You use this function to set up the program's effects. Important • The sample's "main output" destination determines the effect that the sample receives. In particular, the A3000 does not apply any effect to samples whose main output is set to off or to Stereo. To apply an effect to a sample, make sure that the sample's main output is set to Effect1, Effect2, or Effect3. (176) • Note that you can also adjust the "main output" setting using the Easy Edit function. (119). EFFECT - EfType (Select the Effect Types) Selects effect types and effect-block interconnection for the program. PLAY EDIT REC DISK UTILITY PROGRAM SAMPLE EASY EDIT TRIM / LOOP MAP / OUT FILTER RECORD SETUP METER PROGRAM SAMPLE SEQUENCE TOTAL EQ PANEL PLAY SEQUENCE EFFECT EG EFFECT VOLUME MASTER SETUP LFO EXT CTRL DISK SYSTEM CONTROL MIDI / CTRL MONITOR IMPORT MIDI Turn Knob 1 to select EfType. Turn action Push action Knob 1 Knob 2 Knob 1 Knob 2 Knob 3 Knob 4 Knob 5 - Use this page to assign a specific effect to each of the effect blocks (Effect 1, Effect 2, and Effect 3), and to set the interconnection (if any) among these blocks. Change Page Select P/S • Turn the knob to change to a different page within the EFFECT function. Available pages are: EfType (this page), Efct1, Efct2, Efct3, In&Out, and EdType. • Push the knob to move to the Program/Sample Selection screen. (95) Effect1 = Through, Scratch,...,Canyon Bypass • Turn the knob to select the effect type to be applied as Effect 1. For information about available selections, refer to the "Effect type list" in the appendix. (335). • Push the knob to toggle Effect 1 on or off. Press once to switch the effect off (so that a "- - -" appears above the knob); press again to switch the effect back on. Chapter 4 PLAY Mode 121