Yamaha A3000 Owner's Manual - Page 240

EFFECT Function EFFECT Function The EFFECT function sets the recording effect(s). If the recording-effect switch is enabled, the A3000 passes the incoming signal through the selected effect(s) before recording it into memory. Most of the settings provided here are identical to those that you use to set up the program effects. The explanations below describe only those parameters that are different. For detailed information, refer to the explanations for the PLAY | EFFECT function. (121) EFFECT - EfType (Select the Effect Types) Selects effect types and sets effect use on or off. PLAY EDIT REC DISK UTILITY PROGRAM SAMPLE EASY EDIT TRIM / LOOP MAP / OUT FILTER RECORD SETUP METER PROGRAM SAMPLE SEQUENCE TOTAL EQ PANEL PLAY SEQUENCE EFFECT EG EFFECT VOLUME MASTER SETUP LFO EXT CTRL DISK SYSTEM CONTROL MIDI / CTRL MONITOR IMPORT MIDI Turn Knob 1 to select EfType. Turn action Push action Knob 5 Knob 1 Knob 2 Knob 3 Knob 4 Knob 5 - • With the exception of the Knob 5 setting, this page is identical to the corresponding PLAY| EFFECT page (121). Knob 5, however, sets the recording-effect switch rather than the effect-block interconnection. • Note that the A3000 always uses a "1→2→3→" connection type when applying recording effects. The incoming signal passes through Effect 1 first, then through Effect 2, and then through Effect 3. • For information about the available effect types, refer to the "Effect type list" in the Appendix. (335) RecEfSW = off, 1→2→3→ • This setting determines whether the A3000 passes the incoming signal through the effect blocks before recording it. If you set the value to off, the signal does not receive any effect. If you set the value to 1→2→3→, the signal passes sequentially through all three blocks. • Note that this setting is forced to off if the Input setting (227) is set to STOut, DIGITAL, or OPTICAL. 238 Chapter 6 RECORDING Mode