Yamaha A3000 Owner's Manual - Page 257
>PHYS_FMT, NumOfPart
UPC - 027108936673
View all Yamaha A3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 257 highlights
COMMAND Pages Knob 1 Knob 2 Knob 3 Knobs 4, 5 Change Page >PHYS_FMT • Turn the knob to change to a different command page. • Push the knob when you are ready to execute the format. The A3000 returns a confirmation screen. Push Knob 5 (>YES) to proceed with the format, or Knob 4 (>NO) to cancel. ID = 0,...,7 Use this knob to select the disk that you want to format, by its SCSI ID. Be careful to select the correct ID; do not select the wrong disk, or an unused ID, or the ID of the A3000 itself. NumOfPart = 1,...,8 • Use this knob to set the number of partitions that you want to create on the disk. If you set the value to 1, the A3000 sets the entire disk up as a single partition. • Remember that the A3000 cannot use partitions larger than 512KB. Consider the total size of your disk, and set enough partitions so that partition size does exceed 512KB. Name The bottom line of the screen shows the name of the disk or of the first partition (if you have created multiple partitions). If you wish to change the name, push Knob 4 or Knob 5 to proceed to the name editing screen. For information about how to edit name strings, see "Entering Names" (88). If you have created multiple partitions, the first partition takes the name shown here, while subsequent partitions take the same name followed by a sequential number (located at the far right side of the name field). If you have created a 3-partition disk under the name "HardDisk", for example, then the first partition is named "HardDisk", the second is named "HardDisk 1", and the third is named "HardDisk 2." Chapter 7 Chapter 7 DISK Mode 255