Yamaha A3000 Owner's Manual - Page 311

MIDI Function MIDI - RcvFlt (Receiving Filter) Sets up filtering of MIDI data. PLAY EDIT REC DISK UTILITY PROGRAM SAMPLE EASY EDIT TRIM / LOOP MAP / OUT FILTER RECORD SETUP METER PROGRAM SAMPLE SEQUENCE TOTAL EQ PANEL PLAY SEQUENCE EFFECT EG EFFECT VOLUME MASTER SETUP LFO EXT CTRL DISK SYSTEM CONTROL MIDI / CTRL MONITOR IMPORT MIDI Turn Knob 1 to select RcvFlt. Turn action Push action Knob 1 Knob 2 Knob 3 Knob 4 Knob 1 Knob 2 - Knob 3 - Knob 4 - Knob 5 - This page selects the types of MIDI messages accepted by the A3000. The A3000 accepts messages of a given type only if the corresponding parameter is set to enable. If the setting is disable, the A3000 filters out (ignores) messages of this type. Note that the settings that you make here remain effective when you are recording a sequence. If you disable control-change messages, for example, then the sequence will not register any control-change messages that are received during recording. Change Page Select P/S • Turn the knob to change to a different page within the MIDI function. Available pages are: Receive, Adjust, RcvFlt (this page), and Bulk. • Push the knob to move to the Program/Sample Selection screen. (95) CtrlCng = enable, disable Set this to enable if you want to allow control-change data to pass to the tone generator. Set to disable if you want the A3000 to ignore (filter out) all control-change data. AftrTch = enable, disable Set this to enable if you want to allow aftertouch data to pass to the tone generator. Set to disable if you want the A3000 to ignore (filter out) all aftertouch data. PtchBnd = enable, disable Set this to enable if you want to allow pitchbend data to pass to the tone generator. Set to disable if you want the A3000 to ignore (filter out) all pitchbend data. Chapter 8 Chapter 8 UTILITY Mode 309