Yamaha A3000 Owner's Manual - Page 319
Now go to the rear panel and remove the 3 screws holding the expansion
UPC - 027108936673
View all Yamaha A3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 319 highlights
Bottom Installing the AIEB1 I/O Expansion Board Top Rear panel 4. Hold the two sides of the cover and slide the cover straight back (over the rear panel) and off. Appendix 5. Now go to the rear panel and remove the 3 screws holding the expansionboard coverplate in place. Take the coverplate out. Keep the 3 silver-colored screws at hand, since you will need them to fasten the expansion board. (Note that these screws are not the same type as those removed at Step 3.) You will not need the coverplate again unless you decide to remove the expansion board. NOTE: Although the above illustration does not show the SCSI board mounted in the A3000, please note that there is no need to remove the SCSI board when installing SIMMs. Appendix 317
Installing the AIEB1 I/O Expansion Board
317
Appendix
Appendix
4.
Hold the two sides of the cover and slide the cover straight back (over the rear
panel) and off.
5.
Now go to the rear panel and remove the 3 screws holding the expansion-
board coverplate in place. Take the coverplate out.
Keep the 3 silver-colored screws at hand, since you will need them to fasten the expan-
sion board. (Note that these screws are not the same type as those removed at Step 3.)
You will not need the coverplate again unless you decide to remove the expansion board.
NOTE:
Although the above illustration does not show the SCSI board mounted in the A3000, please note
that t
here is no need
to remove the SCSI board when installing SIMMs.
Bottom
Top
Rear panel