Yamaha A3000 Owner's Manual - Page 245
MONITOR Function
UPC - 027108936673
View all Yamaha A3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 245 highlights
MONITOR Function MONITOR Function This function sets up the monitoring feature, so that you can monitor the input signal as you record it. You can also use this function to generate a metronome click that you can use to help time your recording. MONITOR - Monitor Sets up the input monitor. PLAY EDIT REC DISK UTILITY PROGRAM SAMPLE EASY EDIT TRIM / LOOP MAP / OUT FILTER RECORD SETUP METER PROGRAM SAMPLE SEQUENCE TOTAL EQ PANEL PLAY SEQUENCE EFFECT EG EFFECT VOLUME MASTER SETUP LFO EXT CTRL DISK SYSTEM CONTROL MIDI / CTRL MONITOR IMPORT MIDI Turn Knob 1 to select Monitor. Turn action Push action Knob 1 Knob 2 Knob 3 Knob 1 Knob 2 - Knob 3 - Knob 4 - Knob 5 - Use this page to switch monitoring on or off, to select the monitor output, and to set the monitor level. Change Page Select P/S • Turn the knob to switch between the function's Monitor and Click pages. • Push the knob to move to the Program/Sample Selection screen. (95) Output = Stereo, ASL&R, AS1&2, AS3&4, AS5&6, DIG&OPT • Turn the knob to select the output location for the monitor signal. • Note that the AS1&2, AS3&4, AS5&6, and DIG&OPT settings are effective only if you have installed the optional AIEB1 expansion board. • This setting is forced to Stereo if the A3000 is taking its input from the DIGITAL or OPTICAL connector (if the Input setting in the RecData page (227) is set to DIGITAL or OPTICAL). Level = 0,...,127 • Turn the knob to set the monitor's output level. (This setting does not affect the level of the input signal.) • Note that you cannot adjust this setting if using OPTICAL or DIGITAL input. Chapter 6 Chapter 6 RECORDING Mode 243