Yamaha A3000 Owner's Manual - Page 168
TRIM/LOOP, Edit Loop Addresses
UPC - 027108936673
View all Yamaha A3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 168 highlights
TRIM/LOOP Function TRIM/LOOP - Loop (Edit Loop Addresses) Sets loop start and loop end addresses. PLAY EDIT REC DISK UTILITY PROGRAM SAMPLE EASY EDIT TRIM / LOOP MAP / OUT FILTER RECORD SETUP METER PROGRAM SAMPLE SEQUENCE TOTAL EQ PANEL PLAY SEQUENCE EFFECT EG EFFECT VOLUME MASTER SETUP LFO EXT CTRL DISK SYSTEM CONTROL MIDI / CTRL MONITOR IMPORT MIDI Turn Knob 1 to select Loop. Turn action Push action Knob 1 Knob 2 Knob 1 Knob 2 Knob 3 Knob 4 Knob 5 Use this page to select the start and end points for the playback loop. FYI • To set the loop mode (loop direction and type), use the WvMode page. (168) • You can use the EndType setting on the Configure page to select the method for displaying the end address. (161) Change Page Select P/S • Turn the knob to change to a different page within the TRIM/LOOP function. Available pages are: Config, Wave, Loop (this page), and WvMode. • Push the knob to move to the Program/Sample Selection screen. (95) LpStart = loop start address,...,end address Realtime Set • Sets the start point of the loop on the waveform. The concept is illustrated below. • Note that actual loop handling depends on the loop-mode setting. (168) Start Address Playback Area of Waveform End Address Looping Area Loop Start Address Loop End Address 166 Chapter 5 EDIT Mode