Yamaha A3000 Owner's Manual - Page 239

METER Function METER - TrgLvl Sets the recording trigger levels. PLAY EDIT REC DISK UTILITY PROGRAM SAMPLE EASY EDIT TRIM / LOOP MAP / OUT FILTER RECORD SETUP METER PROGRAM SAMPLE SEQUENCE TOTAL EQ PANEL PLAY SEQUENCE EFFECT EG EFFECT VOLUME MASTER SETUP LFO EXT CTRL DISK SYSTEM CONTROL MIDI / CTRL MONITOR IMPORT MIDI Turn Knob 1 to select TrgLvl. Turn action Push action Knob 1 Knob 4 Knob 5 Knob 1 Knob 2 - Knob 3 - Knob 4 - Knob 5 - • Use this page to set the input levels required to start and stop recording. These settings are effective only if you have selected SrcIn and/or SrcOut triggering at the SETUP Trigger page (234). • Use the SrcIn value to set the level for the recording start trigger. Use SrcOut to set the level for the stop trigger. • You can use the monitor feature to listen to the sound of the signal while this page is on the display. Use the MONITOR function (243) to switch monitoring on or off, and to select the output destination for the monitor signal. Change Page Select P/S • Turn the knob to switch between the function's Meter and TrgLvl pages. • Push the knob to move to the Program/Sample Selection screen. (95) SrcIn = 0,...,63 • This value sets the input level that triggers the start of recording. The setting is meaningful only if you have set the Trigger page's StartBy parameter to SrcIn. • The display's upper-level triangle mark (v) points to the position of the SrcIn level on the graphic level meter. SrcOut = 0,...,63 • This value sets the input level that triggers the end of recording. The setting is meaningful only if you have set the Trigger page's StopBy parameter to SrcOut. • The display's lower-level triangle mark (v) points to the position of the SrcOut level on the graphic level meter. Chapter 6 Chapter 6 RECORDING Mode 237