Yamaha A3000 Owner's Manual - Page 81
Triple Effect System
UPC - 027108936673
View all Yamaha A3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Chapter 3 Sample Output Destinations and Effects Program Sample Main Output off Stereo Effect1 Effect2 Effect3 Effect1 Effect2 Effect3 STEREO OUT, PHONES Sound generation Mix Assignable Output off ASL&R AS1&2 AS3&4 AS5&6 DIG&OPT ASSIGNABLE OUT (L, R) ASSIGNABLE OUT (1, 2)* ASSIGNABLE OUT (3, 4)* ASSIGNABLE OUT (5, 6)* DIGITAL OUT,* OPTICAL OUT* *These jacks are available only if the optional AIEBI expansion board is installed. FYI • You can set the output so that the signal to the STEREO OUT jacks also passes to the DIGITAL OUT and OPTICAL OUT jacks or to any ASSIGNABLE OUT pair. You make this setting using the StOut ("Stereo Out") parameter, located in the UTILITY mode's MASTER function. (299) • You can use a program's Easy Edit feature to change the output destination for any sample within the program. The change is effective at the program level only, and does not alter the output settings within the sample itself. Triple Effect System The A3000 allows each program to use up to three effects. The three effects are implemented as independent, parallel circuits. It is also possible, however, to "rewire" any or all of these circuits into a serial configuration (121). Important As the above illustration suggests, the sample's "main output" setting selects the effect circuit to which the sample's output passes. Notice that the sample does not select the actual effect itself (reverb, delay, and so on). The effects themselves are assigned separately by each program. Chapter 3 Basics 79