Yamaha A3000 Owner's Manual - Page 149

Chapter 5 COMMAND Pages COMMAND Pages This section describes the command screens (command pages) that you can access by pressing the COMMAND key while working in EDIT mode. SAVE Saves object(s) from memory to disk. PLAY EDIT REC DISK UTILITY PROGRAM SAMPLE EASY EDIT TRIM / LOOP MAP / OUT FILTER RECORD SETUP METER PROGRAM SAMPLE SEQUENCE TOTAL EQ PANEL PLAY SEQUENCE EFFECT EG EFFECT VOLUME MASTER SETUP LFO EXT CTRL DISK SYSTEM CONTROL MIDI / CTRL MONITOR IMPORT MIDI Press the COMMAND key, then turn Knob 1 to select >SAVE. Turn action Push action Knob 1 Knob 2 Knob 1 Knob 2 - Knob 3 - Knob 4 - Knob 5 - Use this page to save the selected memory-resident object(s) to disk. You can elect to save all programs, all samples and sample banks, the selected program only (together with all samples used by the program), or a selected sample only. Change Page >SAVE • Turn the knob to change to a different command page. • Push the knob when you are ready to execute the save. The A3000 returns a confirmation prompt. Push Knob 5 (>YES) to proceed with the save, or Knob 4 (>NO) to cancel. • If a name conflict occurs (if the selected object in main memory has the same name as a corresponding object on the target volume), the A3000 prompts for instructions about how to resolve the conflict. (100) Type of Save = All(wipe), AllPgm(wp), Edited, AllSmp, Smp(Bank) Turn the knob to select the object(s) to be saved to disk. Selections are as follows. All(wipe) Saves all memory content to disk. This operation saves all objects currently in memory (all usable programs, all samples, and all sequences) to the destination volume on disk. The operation erases all data already existing in the destination disk volume. [Note: a program is usable if it uses at least one sample or if its "A/D-in" setting is on.] Chapter 5 EDIT Mode 147