Yamaha A3000 Owner's Manual - Page 317
Return the top cover to its original position, and fasten into place with the, screws removed
UPC - 027108936673
View all Yamaha A3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 317 highlights
Installing SIMMs (2) Repeat this step for each SIMM that you wish to install. * If you need to remove a SIMM from a socket, hold open the two hooks on the socket (one at each end) and push on the SIMM so that it moves to the opposite angle from that shown in Figure (2) (toward yourself in the diagram), and then pull the SIMM out. This completes the installation. There is no need to remove the expansion board when installing other devices. 6. Return the top cover to its original position, and fasten into place with the screws removed at Step 3 above. • When remounting the cover, be careful to keep clear of internal cabling, and do not allow cables to be pinched or pulled. • When refastening the three screws on the top, press inward on the top center part of the front panel. 7. Plug in the power cord. • The UTILITY - SYSTEM FreeMem page allows you to verify that the installed SIMM modules were detected correctly. (304) Appendix 315 Appendix