Yamaha A3000 Owner's Manual - Page 203
PEG Mode Settings
UPC - 027108936673
View all Yamaha A3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 203 highlights
EG Function EG - PEGMode (PEG Mode Settings) Sets up the PEG's scaling, velocity sensitivity, and range. PLAY EDIT REC DISK UTILITY PROGRAM SAMPLE EASY EDIT TRIM / LOOP MAP / OUT FILTER RECORD SETUP METER PROGRAM SAMPLE SEQUENCE TOTAL EQ PANEL PLAY SEQUENCE EFFECT EG EFFECT VOLUME MASTER SETUP LFO EXT CTRL DISK SYSTEM CONTROL MIDI / CTRL MONITOR IMPORT MIDI Turn Knob 1 to select PEGMode. Turn action Push action Knob 1 Knob 2 Knob 3 Knob 1 Knob 2 - Knob 3 - Knob 4 - Knob 5 - Use this page to determine how PEG rates vary with velocity and keyboard location, and how the PEG levels vary with velocity. Also use it to set the range for the PEG levels. Change Page Select P/S • Turn the knob to change to a different page within the EG function. Available pages are: AEG, AEGMode, FEGRate, FEGLevel, FEGMode, PEGRate, PEGLevel, and PEGMode (this page). • Push the knob to move to the Program/Sample Selection screen. (95) RateScl = -7,...,+7 This setting determines how the PEG rates (attack, decay, and release rates) vary according to keyboard location (pitch) of the played note. Set the value to 0 to keep rates the same for all keyboard notes. Positive settings cause rates to increase as you move up the keyboard, while negative settings cause rates to decrease as you move up the keyboard. Vel → Rate = -63,...,+63 This value sets the velocity sensitivity for the PEG rates: the amount by these PEG rates (attack, decay, and release rates) vary in response to the velocity (force) of the played note. Set the value to 0 to keep rates the same for all velocities. Positive settings cause rates to increase as velocity increases, while negative settings cause rates to decrease as velocity increases. Chapter 5 Chapter 5 EDIT Mode 201