Yamaha A3000 Owner's Manual - Page 157
Knob 1, Change Knob 2
UPC - 027108936673
View all Yamaha A3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 157 highlights
Chapter 5 COMMAND Pages FADE Sets a fade-in or fade-out for the sample. PLAY EDIT REC DISK UTILITY PROGRAM SAMPLE EASY EDIT TRIM / LOOP MAP / OUT FILTER RECORD SETUP METER PROGRAM SAMPLE SEQUENCE TOTAL EQ PANEL PLAY SEQUENCE EFFECT EG EFFECT VOLUME MASTER SETUP LFO EXT CTRL DISK SYSTEM CONTROL MIDI / CTRL MONITOR IMPORT MIDI Press the COMMAND key, then turn Knob 1 to select >FADE. Turn action Push action Knob 1 Knob 2 Knob 1 Knob 2 - Knob 3 - Knob 4 - Knob 5 - This command selects whether the sample "fades in" or "fades out," and sets the length and type of the fade. Note that fade-in always starts at the start address, while fade-out always ends at the end address. (For information on how to edit the start and end addresses, see page 164.) The following drawing illustrates the concept. Fade In Length Start address Fadeout Length End address Important This command does not operate on sample banks. Change Page >FADE • Turn the knob to change to a different command page. • Push the knob to execute processing. The A3000 returns a confirmation screen. Push Knob 5 (>YES) to proceed, or Knob 4 (>NO) to cancel. In/Out = in, out Turn the knob to select whether the sample uses fade-in or fade-out. Chapter 5 EDIT Mode 155