Yamaha A3000 Owner's Manual - Page 270
DISK Function
UPC - 027108936673
View all Yamaha A3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 270 highlights
DISK Function DISK Function You use the DISK function to select and manage disks (partitions). The A3000 uses the disk that you select as the source for data loads. This selection also determines the volumes that you can select at the VOLUME function (266). You can also use this function to change the SCSI ID of the A3000, and to enable or disable use of connected SCSI disks and CD-ROM drives. Finally, you use this function's command pages to format your disks (both hard disks and floppies), and to create and manage disk partitions. You access the command pages by selecting the DISK function, then pressing the COMMAND key (252 to 258). For details about the relationship between disks, partitions, and volumes, refer to the section entitled "Disks and Volumes" in Chapter 3. (81) DISK - Disk Selects a disk (partition). PLAY EDIT REC DISK UTILITY PROGRAM SAMPLE EASY EDIT TRIM / LOOP MAP / OUT FILTER RECORD SETUP METER PROGRAM SAMPLE SEQUENCE TOTAL EQ PANEL PLAY SEQUENCE EFFECT EG EFFECT VOLUME MASTER SETUP LFO EXT CTRL DISK SYSTEM CONTROL MIDI / CTRL MONITOR IMPORT MIDI Turn Knob 1 to select Disk. Turn action Push action Knob 1 Knob 2 Knob 3 Knob 4 - Knob 5 - • Use this page to select the disk (partition) used for data loads, and to change the disk (partition) name. • The right side of the screen indicates the amount of free space on the currently selected disk (partition). FYI If you find that you are unable to access a connected SCSI disk or CD-ROM, go to the Configure page (270) to check the device's SCSI ID and to make sure the device is enabled ("mounted"). 268 Chapter 7 DISK Mode