Yamaha A3000 Owner's Manual - Page 205
LFO Function
UPC - 027108936673
View all Yamaha A3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 205 highlights
LFO Function LFO Function You use the LFO function to set up the sample's LFO (low-frequency oscillator). The LFO applies a low-frequency modulation to the output volume, filter cutoff frequency, and pitch. FYI The COMMAND key gives you rapid access to a number of helpful commands while you are working with this function. For example, you can use the COMMAND key when you want to save your edit results to disk, or when you want to cancel your new changes and restore the previously saved data. (147) LFO - Common Sets the basic LFO parameters. PLAY EDIT REC DISK UTILITY PROGRAM SAMPLE EASY EDIT TRIM / LOOP MAP / OUT FILTER RECORD SETUP METER PROGRAM SAMPLE SEQUENCE TOTAL EQ PANEL PLAY SEQUENCE EFFECT EG EFFECT VOLUME MASTER SETUP LFO EXT CTRL DISK SYSTEM CONTROL MIDI / CTRL MONITOR IMPORT MIDI Turn Knob 1 to select Common. Turn action Push action Knob 1 Knob 1 Knob 2 - Knob 3 - Knob 4 - Knob 5 - Use this page to set the basic LFO parameters - wave type, oscillation speed, delay, and phase synchronization. Change Page Select P/S • Turn the knob to change to a different page within the LFO function. Available pages are: Common (this page), FltrMod, PtchMod, and AmpMod. • Push the knob to move to the Program/Sample Selection screen. (95) Chapter 5 Chapter 5 EDIT Mode 203