Yamaha A3000 Owner's Manual - Page 58

Sample Editing Using the LFO We will now set the LFO (low-frequency oscillator) to create a vibrato in the ahhhh sample. Procedure 1. Select EDIT mode, LFO function. PLAY EDIT REC DISK UTILITY PROGRAM TRIM / LOOP RECORD SAMPLE MAP / OUT SETUP EASY EDIT FILTER METER PROGRAM SAMPLE SEQUENCE TOTAL EQ PANEL PLAY SEQUENCE EFFECT EG EFFECT VOLUME MASTER SETUP LFO EXT CTRL CONTROL MIDI / CTRL MONITOR DISK SYSTEM IMPORT MIDI 2. Press Knob 1, and then turn Knob 2 or Knob 3 to select the Voice AH sample for editing. Then press Knob 1 again. 3. Turn Knob 1 to select the PtchMod (pitch modulation) screen. Then turn Knob 2 to set the Depth to 30. w The screen now looks like this. 4. Turn Knob 1 to select the Common screen. Turn Knob 2 to set Wave to Triangl. Turn Knob 3 to set Speed to 15; turn Knob 4 to set Delay to 90. 5. Now play and hold a key between C2 and B2 at your keyboard. Notice how a gentle vibrato (pitch waver) begins after the sound has been held for a few moments. In the next section we will begin to do some program editing. If you wish to stop here for a while and switch off the power, please save your edited data to floppy disk (64 to 66). When you are ready to resume operation, please reload the data from the disk (67) and then proceed to the next page. 56 Chapter 2 Trying It Out