Yamaha A3000 Owner's Manual - Page 170
TRIM/LOOP, Set Wave Mode
UPC - 027108936673
View all Yamaha A3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
TRIM/LOOP Function TRIM/LOOP - WvMode (Set Wave Mode) Sets the loop mode and the start-address velocity sensitivity. PLAY EDIT REC DISK UTILITY PROGRAM SAMPLE EASY EDIT TRIM / LOOP MAP / OUT FILTER RECORD SETUP METER PROGRAM SAMPLE SEQUENCE TOTAL EQ PANEL PLAY SEQUENCE EFFECT EG EFFECT VOLUME MASTER SETUP LFO EXT CTRL DISK SYSTEM CONTROL MIDI / CTRL MONITOR IMPORT MIDI Turn Knob 1 to select WvMode. Turn action Push action Knob 1 Knob 2 Knob 3 Knob 1 Knob 2 - Knob 3 - Knob 4 - Knob 5 - • Use this page to select the loop mode and the start-address velocity sensitivity. • The right side of the screen indicates the selected sample's sampling rate. Change Page Select P/S • Turn the knob to change to a different page within the TRIM/LOOP function. Available pages are: Config, Wave, Loop, and WvMode (this page). • Push the knob to move to the Program/Sample Selection screen. (95) LpMode = Select from 6 types. • Sets the loop mode. (Note the you can also use this setting to cause the sample to play back in reverse.) • The six loop modes are illustrated and described on the next page. Vel → Start = -63,...,+63 This value sets the start-address velocity sensitivity: the degree by which the start point varies in response to the velocity (force) of the played note. This feature gives you added control over the attack part of the playback. A value of 0 leaves the start address constant for all velocities. Positive values cause the start-point to move forward (the address to get higher) at higher velocities, and to move backward at lower velocities. Negative settings have the opposite effect. 168 Chapter 5 EDIT Mode