Dell C7765DN Dell Color Multifunction Printer User's Guide - Page 516
Select [Enabled] for [Send E-mail - Port Status] on the [Send E-mail] screen
View all Dell C7765DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 516 highlights
20 Using the Internet Fax Service Installation Procedures This section describes the configuration procedures to use the Internet Fax feature on the machine. The following shows the reference section for each procedure. Step 1 Enabling Port and Setting up TCP/IP 516 Step 2 Configuring E-mail Environment 517 Step 3 Testing the Internet Fax 518 Step 1 Enabling Port and Setting up TCP/IP To use the Internet Fax feature on the machine, enable the ports for the E-mail feature, and set the IP address. The following shows the configuration procedures on the machine. Note • You can configure the settings using Dell Printer Configuration Web Tool. For information on how to use Dell Printer Configuration Web Tool, refer to "Configuring Machine Settings Using Dell Printer Configuration Web Tool" (P.467). 1 Display the [Tools] screen. 1) Press the button. 2) Enter the system administrator's user ID with the numeric keypad or the keyboard displayed on the screen, and select [Enter]. When a passcode is required, select [Next] and enter the system administrator's passcode, and select [Enter]. Note • The default user ID is "admin". • The default passcode is "1111". 3) Select [Tools] on the [Home] screen. 2 Enable ports to use for the E-mail feature. 1) Select [Connectivity & Network Setup]. 2) Select [Port Settings]. 3) Select [Receive E-mail], and then select [Change Settings]. 4) Select [Port Status], and then select [Change Settings]. 5) Select [Enabled], and then select [Save]. 6) Select [Close]. 7) Select [Enabled] for [Send E-mail - Port Status] on the [Send E-mail] screen as described above. 8) Select [Close] repeatedly until the [Tools] screen is displayed. 3 Set an IP address and the other addresses. Skip this step if an IP address is already set. If DHCP or BOOTP is available in your environment, configure the method for obtaining the address. If an IP address cannot be obtained automatically, or if manual configuration is preferred, confirm the settings of an IP address, a subnet mask, and a gateway address. For information on how to set an IP address, refer to "Protocol Settings" (P.363). 4 Select [Close] repeatedly until the [Tools] screen is displayed. 5 Select [Close]. 516