Netgear GS516TP Software Administration Manual - Page 35
Green Ethernet Configuration, System > Management > Green Ethernet > Green Ethernet Interface
View all Netgear GS516TP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
GS516TP Gigabit Smart Switches To add a static entry to the local DNS table: 1. Select System > Management > DNS > Host Configuration. 2. Specify the static host name to add. • Enter up to 158 characters. • Each label (separated by periods) can be up to 63 characters. 3. Specify the IP address in standard IPv4 dot notation to associate with the hostname. 4. Click ADD. The entry displays in the list. The Dynamic Host Configuration table shows host name-to-IP address entries that the switch has learned. The following table describes the dynamic host fields. Table 4. Dynamic Host Configuration Table Fields Field Description Host Lists the host name you assign to the specified IP address. Type The type of the dynamic entry. IPv4/IPv6 Address Lists the IP address associated with the host name. Click CLEAR to delete dynamic host entries. The table repopulates with entries as they are learned. Green Ethernet Configuration The Green Ethernet features allow the switch to reduce power consumption on a per-port basis. Each switch can support one or more of the following features: • Auto Power Down Mode. When the Auto Power Down mode is enabled and the port link is down, the physical layer (PHY) automatically shuts down for a short period and wakes up to check link pulses. This mode reduces power consumption on the port when no link partner is present. • Short Cable Mode. With Short Cable mode enabled, the PHY goes into low-power mode when the cable length is less than a certain limit. • Energy Efficient Ethernet (EEE) Mode. EEE enables ports to enter a low-power mode to reduce power consumption during periods of low link utilization. EEE is defined by IEEE 802.3az. EEE enables both the send and receive sides of the link to disable some functionality for power savings when the link is lightly loaded. To configure the Green Ethernet Interface features: 1. Select System > Management > Green Ethernet > Green Ethernet Interface Configuration. 2. Enable or disable the Auto Power Down Mode. 35