Nokia 9000i Nokia 9000i User Guide in English - Page 110

13-10 Detailed menus list Phone settings (Menu 4) Lights (Menu 4 1) The keypad and display of the phone interface are fitted with lights to make them easy to read. When the communicator is used as a handportable phone or is connected to a charger, this setting determines whether the lights remain on for 15 seconds after the last keystroke or an incoming call alert (On) or remain permanently off (Off). The lights can be switched on for 15 seconds by pressing quickly even if Off is selected. When the communicator is connected to a handsfree car kit, the lights always remain on (On) or extinguish after 15 seconds (Off). Ringing volume (Menu 4 2) The ringing tone will be heard when you receive a call. There are several ringing tone volume levels available. If you have set the communicator to Silent or Beep in Menu 10, the ringing tone will not be heard. Ringing tone (Menu 4 3) You can select from a range of different tone patterns. When you change the ringing tone, a short sample tone will be heard. If you have set the communicator to silent service (Menu 10), the ringing tone will not be heard. Keypad tones (Menu 4 4) A short tone is sounded each time you press a key. You can select a suitable volume level or set the keypad tones off. If you have set the communicator in silent service within Menu 10, the keypad tones will not be heard. Auto DTMF length (Menu 4 5) Choose Long (default) or Short to set the duration of the DTMF tones that you have programmed into the communicator. Warning tones (Menu 4 6) A warning tone, i.e., error or confirmation tone will sound, for example, when the network is currently too busy to allow new calls or the battery charge is too low. If you have set the communicator to silent service (Menu 10), the warning tones will not be heard. One touch dialing (Menu 4 7) When this function is set on, you can dial phone numbers stored in speed dial locations by simply pressing and holding the assigned speed dial key. Automatic answer (Menu 4 8) When this function is set on, the communicator will automatically receive an incoming call. This function can only be used when the communicator is connected to an approved handsfree car kit which is equipped with the ignition sense option. The ignition sense option has to be installed and the ignition must be switched on. Note that this function works with voice calls only. Date and time (Menu 4 9) You can select whether the date and time are shown on the display. Cell info display (Menu 4 10) When this function is set on, the phone interface will indicate when it is using a network cell based on Micro Cell Network (MCN) technology. The setting will remain in effect even if the SIM card is changed or the phone interface is switched off. Note: The communicator consumes more power when the Cell info display is on. Own number sending (Menu 4 11) This function setting determines whether the phone number of your SIM card is revealed to the receiving end. This function works only in networks which allow you to view the caller's phone number. For subscription to this service, contact your network operator. Choose Preset, On or Off. Preset selects the preferential setting (On or Off) that you have agreed upon with your network operator. When you change the SIM card, the Preset setting is automatically selected.