ZyXEL Vantage CNM User Guide - Page 224

Chapter 7 Device Advanced Settings The following table describes the labels in this screen. Table 84 Device Operation > Device Configuration > Advanced > NAT > Trigger Port > Edit LABEL DESCRIPTION Name Type a unique name (up to 15 characters) for identification purposes. All characters are permitted - including spaces. Incoming Start Port Incoming is a port (or a range of ports) that a server on the WAN uses when it sends out a particular service. The device forwards the traffic with this port (or range of ports) to the client computer on the LAN that requested the service. Type a port number or the starting port number in a range of port numbers. Incoming End Port Type a port number or the ending port number in a range of port numbers. Trigger Start The trigger port is a port (or a range of ports) that causes (or triggers) the Port device to record the IP address of the LAN computer that sent the traffic to a server on the WAN. Trigger End Port Apply Cancel Type a port number or the starting port number in a range of port numbers. Type a port number or the ending port number in a range of port numbers. Click this to save your changes back to the device. Click this to return to the previous screen. 7.5 Static Route This section shows you how to configure the Static Route screens. These screens may vary depending on which model you're configuring. Please see the device's User's Guide for more information about any of these screens or fields. 7.6 Static Route Use this screen to tell the device about networks that are not directly connected to the device. To open this screen, click a device, click Device Operation in the 224 Vantage CNM User's Guide