ZyXEL Vantage CNM User Guide - Page 368

Chapter 14 Object 14.3.2 Force User Authentication Policy Add/Edit Screen Use this screen to specify a condition when users must log in or do not have to log in to the ZyWALL before their HTTP traffic can pass through the ZyWALL. Figure 163 Device Operation > Device Configuration > Object > User/Group > Setting > Force User Authentication Policy Add/Edit The following table describes the labels in this screen. Table 146 Device Operation > Device Configuration > Object > User/Group > Setting > Force User Authentication Policy Add/Edit LABEL DESCRIPTION Enable Select this if you want this condition to be active. Description Enter a description for this condition. It can be up to 60 printable ASCII characters long. Authentication Select whether users must log in (force) or whether users do not have to log in (skip) when this condition is checked and satisfied. Source Address Select a source IP address object or select Create Object to configure a new one. Destination Address Schedule Apply Cancel Select any if this condition applies to traffic from all source addresses. Select the destination address of traffic to which this condition applies or select Create Object to configure a new one. Select any if this condition applies to traffic from all destination addresses. Select the schedule object that specifies when this condition applies or select Create Object to configure a new one. Select none if this condition always applies. Select this to save your changes and return to the previous screen. Select this to return to the previous screen without saving any changes. 368 Vantage CNM User's Guide