ZyXEL Vantage CNM User Guide - Page 82
Table 22
View all ZyXEL Vantage CNM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
Chapter 5 Device Network Settings The following table describes the labels in this screen. Table 22 Device Operation > Device Configuration > Network > WAN > WAN1/2 PPPoE (ZyNOS ZyWALL with two WAN ports) LABEL DESCRIPTION ISP Parameters for Internet Access Encapsulation The PPPoE choice is for a dial-up connection using PPPoE. The router supports PPPoE (Point-to-Point Protocol over Ethernet). PPPoE is an IETF standard (RFC 2516) specifying how a personal computer (PC) interacts with a broadband modem (for example, DSL, cable, wireless, etc.) connection. Operationally, PPPoE saves significant effort for both the end user and ISP/carrier, as it requires no specific configuration of the broadband modem at the customer site. By implementing PPPoE directly on the router rather than individual computers, the computers on the LAN do not need PPPoE software installed, since the router does that part of the task. Further, with NAT, all of the LAN's computers will have access. Service Name Type the PPPoE service name provided to you. PPPoE uses a service name to identify and reach the PPPoE server. User Name Type the user name given to you by your ISP. Password Type the password associated with the user name above. Retype to confirm Password Type your password again to make sure that you have entered is correctly. Nailed-Up Connection Select this if you do not want the connection to time out. Idle Timeout This value specifies the time in seconds that elapses before the device automatically disconnects from the PPPoE server. Authentication Use the drop-down list box to select an authentication protocol for Type outgoing calls. Options are: CHAP/PAP - Your Vantage CNM accepts either CHAP or PAP when requested by this remote node. CHAP - Your Vantage CNM accepts CHAP only. PAP - Your Vantage CNM accepts PAP only. WAN IP Address Assignment Get automatically from ISP Select this option If your ISP did not assign you a fixed IP address. This is the default selection. Use Fixed IP Address Select this option If the ISP assigned a fixed IP address. My WAN IP Address Enter your WAN IP address in this field if you selected Use Fixed IP Address. Private This parameter determines if the device will include this route to a remote node in its RIP broadcasts. Select this check box to keep this route private and not included in RIP broadcasts. Clear this check box to propagate this route to other hosts through RIP broadcasts. Advanced Setup 82 Vantage CNM User's Guide