ZyXEL Vantage CNM User Guide - Page 277

Chapter 9 Device Network Settings Table 108 Device Operation > Device Configuration > Network > Interface > VLAN > Add/Edit (continued) LABEL DESCRIPTION Enable Select this to turn on the connection check. Check Method Select the method that the gateway allows. Select icmp to have the ZyWALL regularly ping the gateway you specify to make sure it is still available. Select tcp to have the ZyWALL regularly perform a TCP handshake with the gateway you specify to make sure it is still available. Check Period Enter the number of seconds between connection check attempts. Check Timeout Enter the number of seconds to wait for a response before the attempt is a failure. Check Fail Tolerance Enter the number of consecutive failures before the ZyWALL stops routing through the gateway. Ping Default Gateway Select this to use the default gateway for the connectivity check. Ping this address Select this to specify a domain name or IP address for the connectivity check. Enter that domain name or IP address in the field next to it. Apply Click Apply to save your changes back to the ZyWALL. Cancel Click Cancel to exit this screen without saving. 9.4 Bridge Summary This screen lists every bridge interface and virtual interface created on top of bridge interfaces. To access this screen, click Device Operation > Device Configuration > Network > Interface > Bridge. Figure 119 Device Operation > Device Configuration > Network > Interface > Bridge Each field is described in the following table. Table 109 Device Operation > Device Configuration > Network > Interface > Bridge LABEL DESCRIPTION # This field is a sequential value, and it is not associated with any interface. Name This field displays the name of the interface. Vantage CNM User's Guide 277