ZyXEL Vantage CNM User Guide - Page 73
Device Operation > Device Configuration > Network > WAN > ISP, PPPoE - ZyNOS ZyWALL one - default password
View all ZyXEL Vantage CNM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Chapter 5 Device Network Settings The following table describes the labels in the PPPoE screen. Table 19 Device Operation > Device Configuration > Network > WAN > ISP (PPPoE) - ZyNOS ZyWALL (one WAN port) LABEL DESCRIPTION WAN:ISP Encapsulation The PPPoE choice is for a dial-up connection using PPPoE. The router supports PPPoE (Point-to-Point Protocol over Ethernet). PPPoE is an IETF Draft standard (RFC 2516) specifying how a personal computer (PC) interacts with a broadband modem (for example, xDSL, cable, wireless, etc.) connection. Operationally, PPPoE saves significant effort for both the end user and ISP/carrier, as it requires no specific configuration of the broadband modem at the customer site. By implementing PPPoE directly on the router rather than individual computers, the computers on the LAN do not need PPPoE software installed, since the router does that part of the task. Further, with NAT, all of the LAN's computers will have access. PPP Over Ethernet Service Name Type the PPPoE service name provided to you. PPPoE uses a service name to identify and reach the PPPoE server. User Name Type the user name given to you by your ISP. Password Type the password associated with the User Name above. Retype to confirm Password Type your password again to make sure that you have entered it correctly. Nailed-Up Connection Select Nailed-Up Connection if you do not want the connection to time out. Idle Timeout This value specifies the time in seconds that elapses before the router automatically disconnects from the PPPoE server. Authentication Use the drop-down list box to select an authentication protocol for Type outgoing calls. Options are: CHAP/PAP - Your Vantage CNM accepts either CHAP or PAP when requested by this remote node. CHAP - Your Vantage CNM accepts CHAP only. PAP - Your Vantage CNM accepts PAP only. WAN:IP WAN IP Address Assignment Select Get automatically from ISP If your ISP did not assign you a fixed IP address. This is the default selection. Select Use fixed IP address If the ISP assigned a fixed IP address. My WAN IP Address Enter your WAN IP address in this field if you selected Use Fixed IP Address. Private This parameter determines if the device will include the route to this remote node in its RIP broadcasts. If set to Yes, this route is kept private and not included in RIP broadcast. If No, the route to this remote node will be propagated to other hosts through RIP broadcasts. Advanced Setup Vantage CNM User's Guide 73