ZyXEL Vantage CNM User Guide - Page 501
Monitor > 3G Monitor > Show Details 3G down, Budget Control enabled
View all ZyXEL Vantage CNM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 501 highlights
Chapter 24 3G Monitor The following table describes the labels in this screen. Table 222 Monitor > 3G Monitor > Show Details (3G down, Budget Control enabled) LABEL DESCRIPTION Device Name This is the name of the device where the 3G card is installed. 3G Connection Status This displays Down when the 3G connection is down or not activated. This displays Initializing when the selected device is configuring the 3G card with AT commands. This displays Ready to Connect when the 3G connection is idle before the selected device triggers a call. This displays Connecting when the 3G card is trying to connect to a network but has not received a response from the base station. This displays Connected when the 3G connection is up. This displays Disconnecting when the selected device is dropping the 3G connection. This field also displays whether the selected device is connected to a UMTS/HSDPA network or GPRS/EDGE network. This field also displays the type of the network to which the selected device is connected. The network type varies depending on the 3G card you inserted and could be UMTS, HSDPA, GPRS or EDGE when you insert a GSM 3G card, or 1xRTT, EVDO Rev.0 or EVDO Rev.A when you insert a CDMA 3G card. IP/Netmask IP Assignment Click Dial to dial up the 3G WAN connection. This shows the port's IP address and subnet mask. For the WAN, if the selected device gets its IP address automatically from an ISP, this displays DHCP client when you're using Ethernet encapsulation and IPCP Client when you're using PPPoE or PPTP encapsulation. Static displays if the WAN port is using a manually entered static (fixed) IP address. Service Provider Roaming Network For the LAN, WLAN or DMZ, DHCP server displays when the selected device is set to automatically give IP address information to the computers connected to the LAN. DHCP relay displays when the selected device is set to forward IP address assignment requests to another DHCP server. Static displays if the LAN port is using a manually entered static (fixed) IP address. In this case, you must have another DHCP server on your LAN, or else the computers must be manually configured. For the dial backup port, this shows N/A when dial backup is disabled and IPCP client when dial backup is enabled. This displays the name of your network service provider or Limited Service when the signal strength is too low or the ISP is limiting your access. This field is available only when you insert a 3G card that supports the roaming feature. Last Connection Up Time This displays whether the card is able to connect to other ISPs' base stations. This displays how long the 3G connection has been up. Vantage CNM User's Guide 501