ZyXEL Vantage CNM User Guide - Page 390

Chapter 15 AAA 15.3 Configuring a Default RADIUS Server User this screen to configure the default external RADIUS server to use for user authentication. Click Device Operation > Device Configuration > Object > AAA Server > RADIUS to display the screen as shown. Figure 178 Device Operation > Device Configuration > Object > AAA Server > RADIUS > Default The following table describes the labels in this screen. Table 161 Device Operation > Device Configuration > Object > AAA Server > RADIUS > Default LABEL DESCRIPTION Host Enter the IP address (in dotted decimal notation) or the domain name (up to 63 alphanumeric characters) of a RADIUS server. Authentication Port The default port of the RADIUS server for authentication is 1812. You need not change this value unless your network administrator instructs you to do so with additional information. Key Enter a password (up to 15 alphanumeric characters) as the key to be shared between the external authentication server and the ZyWALL. Timeout The key is not sent over the network. This key must be the same on the external authentication server and the ZyWALL. Specify the timeout period (between 1 and 300 seconds) before the ZyWALL disconnects from the RADIUS server. In this case, user authentication fails. Apply Reset Search timeout occurs when either the user information is not in the RADIUS server or the RADIUS server is down. Click Apply to save the changes. Click Reset to start configuring this screen again. 390 Vantage CNM User's Guide