ZyXEL Vantage CNM User Guide - Page 306
IP Static Route Screen
View all ZyXEL Vantage CNM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 306 highlights
Chapter 9 Device Network Settings Table 119 Device Operation > Device Configuration > Network > Routing > Policy Route > Edit (continued) LABEL DESCRIPTION Maximum Bandwidth Specify the maximum bandwidth (from 1 to 1048576) allowed for the route in kbps. If you enter 0 here, there is no bandwidth limitation for the route. If the sum of the bandwidths for routes using the same next hop is higher than the actual transmission speed, lower priority traffic may not be sent if higher priority traffic uses all of the actual bandwidth. Bandwidth Priority To reserve bandwidth for traffic that does not match any of the policy routes, leave some of the interface's bandwidth unbudgeted and do not enable Maximize Bandwidth Usage. Enter a number between 1 and 7 to set the priority for traffic. The smaller the number, the higher the priority. If you set the maximum bandwidth to 0, the bandwidth priority will be changed to 0 after you click Apply. That means the route has the highest priority and will get all the bandwidth it needs up to the maximum available. A route with higher priority is given bandwidth before a route with lower priority. Maximize Bandwidth Usage Apply Cancel If you set routes to have the same priority, then bandwidth is divided equally amongst those routes. Select this check box to have the ZyWALL divide up all of the interface's unallocated and/or unused bandwidth among the policy routes that require bandwidth. Do not select this if you want to reserve bandwidth for traffic that does not match any of the policy routes. Click Apply to save your changes back to the ZyWALL. Click Cancel to exit this screen without saving. 9.11 IP Static Route Screen Click Device Operation > Device Configuration > Network > Routing > Static Route to open the Static Route screen. This screen displays the configured static routes. Configure static routes to be able to use RIP or OSPF to propagate the routing information to other routers. Figure 135 Device Operation > Device Configuration > Network > Routing > Static Route 306 Vantage CNM User's Guide