ZyXEL Vantage CNM User Guide - Page 322

Chapter 10 Firewall The following table describes the labels in this screen. Table 128 Device Operation > Device Cofniguration > Firewall > Session Limit > Edit LABEL DESCRIPTION Enable Rule Select this check box to turn on this session limit rule. Description Enter information to help you identify this rule. Use up to 64 printable ASCII characters. Spaces are allowed. User Select a user name or user group to which to apply the rule. Select Create Object to configure a new user account. The rule is activated only when the specified user logs into the system and the rule will be disabled when the user logs out. Otherwise, select any and there is no need for user logging. Address Session Limit per Host OK Cancel Note: If you specified an IP address (or address group) instead of any in the field below, the user's IP address should be within the IP address range. Select a source address or address group for whom this rule applies. Select Create Object to configure a new one. Select any if the policy is effective for every source address. Use this field to set a limit to the number of concurrent NAT/firewall sessions this rule's users or addresses can have. For this rule's users and addresses, this setting overrides the Default Session per Host setting in the general Firewall Session Limit screen. Click OK to save your customized settings and exit this screen. Click Cancel to exit this screen without saving. 322 Vantage CNM User's Guide