ZyXEL Vantage CNM User Guide - Page 304
Device Operation > Device Configuration > Network > Routing > Policy, Route > Edit
View all ZyXEL Vantage CNM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 304 highlights
Chapter 9 Device Network Settings Table 119 Device Operation > Device Configuration > Network > Routing > Policy Route > Edit (continued) LABEL DESCRIPTION Description Enter a descriptive name of up to 31 printable ASCII characters for the policy. Criteria User Select a user name or user group from which the packets are sent. Incoming Select an interface or VPN tunnel through which the incoming packets are received. Source Address Select a source IP address object. Destination Address Select a destination IP address object. Schedule Select a schedule or select Create Object to configure a new one. none means the route is active at all times if enabled. Service Select a service or service group from the drop-down list box. Next-Hop Type Select Auto to have the ZyWALL use the routing table to find a next-hop and forward the matched packets automatically. Select Gateway to route the matched packets to the next-hop router or switch you specified in the Gateway field. You have to set up the nexthop router or switch as a HOST address object first. Select VPN Tunnel to route the matched packets via the specified VPN tunnel. Select Trunk to route the matched packets through the interfaces in the trunk group based on the load balancing algorithm. Gateway VPN Tunnel Trunk Interface Address Translation Select Interface to route the matched packets through the specified outgoing interface to a gateway (which is connected to the interface). This field displays when you select Gateway in the Type field. Select a HOST address object. The gateway is an immediate neighbor of your ZyWALL that will forward the packet to the destination. The gateway must be a router or switch on the same segment as your ZyWALL's interface(s). This field displays when you select VPN Tunnel in the Type field. Select a VPN tunnel through which the packets are sent to the remote network that is connected to the ZyWALL directly. This field displays when you select Trunk in the Type field. Select a trunk group to have the ZyWALL send the packets via the interfaces in the group. This field displays when you select Interface in the Type field. Select an interface to have the ZyWALL send traffic that matches the policy route through the specified interface. Use this section to configure NAT for the policy route. This section does not apply to policy routes that use a VPN tunnel as the next hop. 304 Vantage CNM User's Guide