ZyXEL Vantage CNM User Guide - Page 291

Chapter 9 Device Network Settings Table 113 Device Operation > Device Configuration > Network > Interface > Auxiliary (continued) LABEL DESCRIPTION Initial String Enter the AT command string to initialize the external modem. ATZ is the most common string, but you should check the manual for the external modem for additional commands. Auxiliary Configuration Phone Number Enter the phone number to dial here. You can use 1-20 numbers, commas (,), or plus signs (+). Use a comma to pause during dialing. Use a plus sign to tell the external modem to make an international call. User Name Enter the user name required for authentication. Password Enter the password required for authentication. Retype to confirm Enter the password again to make sure you have not typed it incorrectly. Authentication Select the authentication protocol to use for outgoing calls. Choices Type are: Chap/PAP - The ZyWALL accepts either CHAP (Challenge Handshake Authentication Protocol) or PAP (Password Authentication Protocol), as requested by the computer you are dialing. Chap - The ZyWALL accepts CHAP only. PAP - The ZyWALL accepts PAP only. MSCHAP - The ZyWALL accepts MSCHAP only. Timeout Idle Timeout Apply Reset MSCHAP-V2 - The ZyWALL accepts MSCHAP-V2 only. Type the number of seconds the ZyWALL tries to set up a connection before it stops. Allowed values are 30 - 120. Type the number of seconds the ZyWALL should wait for traffic before it automatically disconnects the connection. Set this field to zero to disable the idle timeout. Allowed values are 0 - 360. Click Apply to save your changes back to the ZyWALL. Click Reset to begin configuring this screen afresh. Vantage CNM User's Guide 291