Dell PowerVault MD3200 CLI Guide - Page 255
Start Storage Array Blink, Start Storage Array iSCSI Refresh
View all Dell PowerVault MD3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 255 highlights
Parameters Parameter Description physicalDisk or physicalDisks Identifies the enclosure and slot where the physical disk resides. Enclosure ID values are 0 to 99. Slot ID values are 0 to 31. You must put brackets ([ ]) around the enclosure ID value and slot ID value. Start Storage Array Blink This command identifies a storage array by turning on the indicator LED for the storage array. Use the stop storageArray blink command to turn off the indicator LED for the storage array. Syntax start storageArray blink Parameters None. Start Storage Array iSCSI Refresh This command initiates a refresh of the network address information for the iSNS server. If the DHCP server is marginal or unresponsive, the refresh operation can take from 2 to 3 minutes to complete. NOTE: This command is for IPv4 only. Syntax start storageArray isnsServerRefresh Parameter None. NOTE: If you used the set storageArray isnsIPv4ConfigurationMethod command to set the configuration but did not set the configuration to DHCP, running the start storageArray isnsServerRefresh returns an error. Script Commands 255