HP Integrity Superdome SX2000 HP Insight Manager WBEM Provider Events Referenc - Page 101
An I/O device is missing from the Core I/O. Probable Cause: Either an I/O device
View all HP Integrity Superdome SX2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Event ID Event Severity 12195 Error 12196 Error 12199 Error 12204 Warning 12207 Warning 12208 Warning 12210 Warning 12217 Error 12218 Error 12222 Error Event Description This is an internal SW error. See Cause/Action. Probable Cause: A CPU has tried to acquired the same semaphore twice which resulted in a deadlock. This is an internal SFW error and is not recoverable. Recommended Action: Collect the entire FPL, SEL, console logs and forward them to the SFW team. Also note all activities around the time of this event. The entire logs must analyzed by the SFW team before further actions can be taken. The system must be cold reset to resume normal operation. WBEM EventID: 6695. WBEM ProviderName: FPL_IndicationProvider. This is an internal SW error. See Cause/Action. Probable Cause: A CPU has tried to acquired the same semaphore twice which resulted in a deadlock. This is an internal SFW error and is not recoverable. Recommended Action: Collect the entire FPL, SEL, console logs and forward them to the SFW team. Also note all activities around the time of this event. The entire logs must analyzed by the SFW team before further actions can be taken. The system must be cold reset to resume normal operation. WBEM EventID: 6696. WBEM ProviderName: FPL_IndicationProvider. The complex profiles between cells in a partition do not match. Data field is unused, earlier events will give more detail. Probable Cause: The Group A or Group C complex profiles didn't match on all cells in the partition. Recommended Action: Push out new complex profiles and reset. WBEM EventID: 6698. WBEM ProviderName: FPL_IndicationProvider. An I/O device is missing from the Core I/O. Probable Cause: Either an I/O device on the Core I/O has failed or the wrong card is plugged into the location of the expected Core I/O. Recommended Action: Replace the specified location with the supported Core I/O card. WBEM EventID: 6699. WBEM ProviderName: FPL_IndicationProvider. fPars PMI handler was unable to Notify a CPU's new owner after a migrate. Probable Cause: OS has not fully set up GPE enable bits with the FSHWA interface Recommended Action: Contact HP support. WBEM EventID: 6701. WBEM ProviderName: FPL_IndicationProvider. fPars PMI handler was unable to Notify a CPU's new owner after a migrate. Probable Cause: OS incorrectly set up the IOSAPIC redirection entry through the FSHWA interface. Recommended Action: Contact HP support. WBEM EventID: 6702. WBEM ProviderName: FPL_IndicationProvider. The operating system set the watchdog timer to time out if it was not reset within a specified time. It was not reset and has timed out. The management processor will now take the action specified when the timer was set. Probable Cause: Operating system has not reset watchdog timer. Recommended Action: Determine why operating system did not reset the timer. WBEM EventID: 6703. WBEM ProviderName: FPL_IndicationProvider. An OS is shutting down due to an MCA (Machine Check Abort) or INIT. Probable Cause: An MCA or INIT occurred. Recommended Action: Analyze the dump + logs for cause. If necessary contact HP Support for assistance. WBEM EventID: 6772. WBEM ProviderName: FPL_IndicationProvider. An OS is shutting down due to a panic. Probable Cause: An OS has panicked. Recommended Action: Analyze the dump + logs for cause. If necessary contact HP Support for assistance. WBEM EventID: 6773. WBEM ProviderName: FPL_IndicationProvider. An instance of CLU FW has an installed firmware revision that is incompatible with the system type. Many system operations will fail until this condition is resolved. Probable Cause: Following an in-the-box system type upgrade, or after a UGUY board was replaced, the CLU FW may not have been updated to an appropriate revision for the system type. Recommended Action: Contact your HP Customer Support Representative to update all firmware entities to revisions that are appropriate for the system type. WBEM EventID: 6771. WBEM ProviderName: FPL_IndicationProvider. Platform Events 101