HP Integrity Superdome SX2000 HP Insight Manager WBEM Provider Events Referenc - Page 50
Data read from the CC Error Mask CSR. Probable Cause: CC to XBC link init failure.
View all HP Integrity Superdome SX2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Event ID Event Severity 8154 Warning 8156 Error 8159 Error 8184 Error 8186 Warning 8187 Error 8188 Error 8189 Error 8190 Error 8194 Warning 8195 Error 8198 Error 8199 Warning 8200 Warning 8202 Error Event Description EFI unable to read initial debug level from the BMC. Probable Cause: BMC not functioning properly. Recommended Action: Reset the BMC. Contact your HP representative to check the BMC. WBEM EventID: 716. WBEM ProviderName: FPL_IndicationProvider. A XBC port was unexpectedly found to not be landmined. Probable Cause: An XBC is indicating a port failure Recommended Action: Validate all of the cells connectivity to the PD Check the XBC chips seating reset the system replace either cells/system backplane. WBEM EventID: 717. WBEM ProviderName: FPL_IndicationProvider. An invalid number of XBC ports were landmined in the system. Probable Cause: Hardware failure: link, crossbar chip, or cell. Recommended Action: Check for hardware failures. Reset backplane to re-initialize fabric. WBEM EventID: 1033. WBEM ProviderName: FPL_IndicationProvider. The backplane was not recognized as one that contains fabric. Probable Cause: An unrecognized backplane is installed. Recommended Action: Contact HP Support Personnel to determine why the backplane was unrecognized. WBEM EventID: 719. WBEM ProviderName: FPL_IndicationProvider. Writing the XIN Error Mask Register to zero failed. Probable Cause: CC Write Failure. Recommended Action: Contact HP Support personnel to analyze the fabric. WBEM EventID: 720. WBEM ProviderName: FPL_IndicationProvider. Dumping error info. Read status of the Primary Mode Register. Probable Cause: CC to XBC link init failure. Contact your HP service representative to check the CC to XBC link. WBEM EventID: 1758. WBEM ProviderName: FPL_IndicationProvider. Data read from the CC Primary Mode CSR. Probable Cause: CC to XBC link init failure. Contact your HP service representative to check the CC to XBC link. WBEM EventID: 722. WBEM ProviderName: FPL_IndicationProvider. Dumping error info. Read status of the CC Error Mask Register. Probable Cause: CC to XBC link init failure. Contact your HP service representative to check the CC to XBC link. WBEM EventID: 723. WBEM ProviderName: FPL_IndicationProvider. Data read from the CC Error Mask CSR. Probable Cause: CC to XBC link init failure. Contact your HP service representative to check the CC to XBC link. WBEM EventID: 724. WBEM ProviderName: FPL_IndicationProvider. The link could not be crossed upon first attempt. Probable Cause: The neighbor port is not routable. The port is either: not connected, landmined, in FE, or contains an SBE or LPE. Recommended Action: Contact HP Support personnel to analyze the fabric. WBEM EventID: 725. WBEM ProviderName: FPL_IndicationProvider. Failed reading an XBC forward progress register. Probable Cause: Fabric access error Recommended Action: Contact HP Support personnel to analyze the fabric. WBEM EventID: 726. WBEM ProviderName: FPL_IndicationProvider. Could not find an adjacent XBC due to broken fabric links. Probable Cause: Possible crossbar failure Recommended Action: Contact HP Support personnel to analyze the crossbar. WBEM EventID: 727. WBEM ProviderName: FPL_IndicationProvider. The run-time verification of a programming assumption has failed. Probable Cause: Hardware in unknown state, or programming bug found. Recommended Action: Upgrade PM firmware to latest revision. If already at current revision, replace UGUY board. WBEM EventID: 728. WBEM ProviderName: FPL_IndicationProvider. An unknown error has been detected by the PDHC firmware. Probable Cause: Hardware in unknown state, or programming bug found. Recommended Action: Upgrade PM firmware to latest revision. If already at current revision, replace UGUY board. WBEM EventID: 729. WBEM ProviderName: FPL_IndicationProvider. Data field contains data meant for firmware debug only. Probable Cause: Debug event. Recommended Action: Contact your hp support representative. WBEM EventID: 2440. WBEM ProviderName: FPL_IndicationProvider. 50 WBEM Provider Event Tables