HP Integrity Superdome SX2000 HP Insight Manager WBEM Provider Events Referenc - Page 54
either the PCI card or the I/O backplane. WBEM EventID: 788. WBEM ProviderName
View all HP Integrity Superdome SX2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Event ID Event Severity 8714 Error 8715 Warning 8716 Error 8717 Warning 8718 Warning 8719 Error 8720 Error 8721 Warning 8722 Error 8723 Error 8745 Warning 8747 Error 8752 Warning 8756 Error Event Description The IO chassis discovered was powered off. Probable Cause: Connected IO chassis is powered off. Recommended Action: Either power on the IO chassis or ignore the error if it is powered off by design. WBEM EventID: 784. WBEM ProviderName: FPL_IndicationProvider. There was an error initializing the LBA. Probable Cause: The LBA component initialization routine failed. Recommended Action: This is an internal system firmware error. Update system firmware or contact a system firmware representative. WBEM EventID: 785. WBEM ProviderName: FPL_IndicationProvider. There was an error querying the LBA width. Probable Cause: Error while writing the LBA phase data Recommended Action: Replace the I/O backplane. WBEM EventID: 786. WBEM ProviderName: FPL_IndicationProvider. There was an error with the LBA phase. Probable Cause: Error while writing the LBA phase data Recommended Action: Replace the I/O backplane. WBEM EventID: 787. WBEM ProviderName: FPL_IndicationProvider. There was an error clearing the LBA. Probable Cause: Unable to clear an error in the LBA Recommended Action: Check other events for the error being generated replace either the PCI card or the I/O backplane. WBEM EventID: 788. WBEM ProviderName: FPL_IndicationProvider. There was an error with the LBA log. Probable Cause: The LBA component could not generate error logs. Recommended Action: This is an internal system firmware error. Update system firmware or contact a system firmware representative. WBEM EventID: 789. WBEM ProviderName: FPL_IndicationProvider. There was an error discovering the LBA. Probable Cause: The wrong backplane type was detected Recommended Action: replace I/O backplane. WBEM EventID: 790. WBEM ProviderName: FPL_IndicationProvider. There was an error configuring the LBA. Probable Cause: Unable to configure the LBA Recommended Action: replace I/O backplane. WBEM EventID: 791. WBEM ProviderName: FPL_IndicationProvider. There was an error scanning the PCI bus. Probable Cause: Could not scan the card in a populated slot. Typically caused by an improperly installed or faulty PCI card. Recommended Action: Reseat or replace the faulty card. WBEM EventID: 792. WBEM ProviderName: FPL_IndicationProvider. There was an error configuring PCI space through the LBA. Probable Cause: Unable to obtain semaphore Recommended Action: reset Update to latest recipe. WBEM EventID: 793. WBEM ProviderName: FPL_IndicationProvider. The OLA cell failed accessing the complex profile. Probable Cause: System firmware was unable to lock either the global or the micro semaphore. Recommended Action: Allow the OLA cell to reboot to BIB, then try the OLA operation again. Or, collect IPMI event logs and contact HP Customer Support for assistance. WBEM EventID: 6954. WBEM ProviderName: FPL_IndicationProvider. Firmware was unable to find a suitable block of main memory to relocate ROM. Probable Cause: Probably caused by lots of PDT entries, or no main memory present. WBEM EventID: 1036. WBEM ProviderName: FPL_IndicationProvider. Cell started OLA but is not configured in the complex profile of the partition. Probable Cause: Cell was issued an OLA command without first updating the complex profile to reflect its slot as configured in the partition. Recommended Action: Update the complex profile to include the new cell. WBEM EventID: 6955. WBEM ProviderName: FPL_IndicationProvider. The Options service received an NVRAM allocation error. Probable Cause: Invalidate NVRAM and reset. WBEM EventID: 808. WBEM ProviderName: FPL_IndicationProvider. 54 WBEM Provider Event Tables