Lexmark T652 Service Manual - Page 109

4062 Error code or message 28x.39 x = bin number Error contents Description/Action Possible repair actions Staple ready home position jam Applies to: StapleSmart finisher The sensor (self priming) within the stapler assembly does not detect a ready staple in the specified time during mechanical reset. 1. Check all the connections on the controller card and the stapler assembly. 2. Remove the staple cartridge and remove all jammed staples. If the cartridge is jammed and can not be removed, go to step 3. 3. Remove the stapler assembly. Go to "SFP stapler assembly stapler unit assembly removal" on page 4-182. 4. Manually rotate the drive gears and reset the stapler. Remove all jammed staples then reinstall the stapler assembly. 5. If problem remains, replace the stapler assembly. Go to "SFP stapler assembly stapler unit assembly removal" on page 4-182. 28x.40 x = bin number Left tamper does not leave home position failure Applies to: StapleSmart finisher The sensor (left tamper HP) does not detect that the tamper has moved from home position. 1. Check all the connections on the output option controller card. 2. Check the tamper drive belt for damage and replace if needed. 3. Replace the left tamper motor assembly. Go to "SFP stapler assembly tamper drive motor assembly removal" on page 4-180. 4. Replace the sensor (tamper HP). Go to "SFP stapler assembly sensor (tamper HP left and right) removal" on page 4-187. 4. Replace the output option if problem remains. Diagnostic information 2-75