Lexmark T652 Service Manual - Page 115

4062 Error code or message 28x.64 x = bin number Error contents Description/Action Possible repair actions Bin clamp motor control timer error during tray holder initial. Applies to: StapleSmart finisher A software failure has occurred with the output option. 1. Turn the machine off/on. 2. Replace the output option if problem remains. 28x.65 x = bin number Bin clamp home position jam Applies to: StapleSmart finisher The bin clamp home position is not detected by the sensor (bin clamp HP) 1. Turn the machine off/on. 2. Replace the output option if problem remains. 28x.66 x = bin number Bin clamp home position jam Applies to: StapleSmart finisher The sensor (bin clamp HP) does not detect that the bin clamp has moved from home position. A software failure has occurred with the output option. 1. Turn the machine off/on. 2. Replace the output option if problem remains. 28x.67 x = bin number Invalid bin clamp manager state. Applies to: StapleSmart finisher 1. Turn the machine off/on. 2. Replace the output option if problem remains. 28x.68 x = bin number Staple ready home position jam Applies to: StapleSmart finisher The sensor (self priming) within the stapler assembly does not detect a ready staple prior to a staple job. Staples empty 1. Check all the connections on the controller card and the stapler assembly. 2. Remove the staple cartridge and remove all jammed staples. If the cartridge is jammed and can not be removed, go to step 3. 3. Remove the stapler assembly. Go to "SFP stapler assembly stapler unit assembly removal" on page 4-182. 4. Manually rotate the drive gears and reset the stapler. Remove all jammed staples then reinstall the stapler assembly. 5. If problem remains, replace the stapler assembly. Go to "SFP stapler assembly stapler unit assembly removal" on page 4-182. Diagnostic information 2-81