Lexmark T652 Service Manual - Page 180

4062 Step Check Check the above sensor for proper connection. Is the above sensor connected properly? Yes Replace the appropriate Sensor (pass through). Go to "250-sheet controller card assembly removal" on page 4-106. No Replace the connection. 7 8 Perform a print test and check the pick arm assembly for the appropriate media tray. Is the media properly picked and advanced out of the appropriate media tray? Go to step 8. Replace the appropriate pick arm assembly. Go to "Operator panel door assembly removal (models X651, X652, X654, and X656)" on page 4-49. 9 Perform a print test and check the main motor assembly. Is the media properly transported through the pass through areas of the media trays? Go to step 9. Replace the main drive motor assembly. Go to "Output cover assembly removal (T650, T652, T654)" on page 4-54. 10 Perform a print test using the appropriate input tray. Does the error continue? Replace the input option. Problem solved. Sensor (pass through) lingering jam service check. Use this procedure for the following jams: • 242.08 • 244.40 • 242.40 • 245.08 • 243.08 • 245.40 • 243.40 244.08 Step 1 Check Check the media size setup and tray guides for all media trays. Does the media size, in use, match the size set for all media trays? Yes Go to step 2. No Replace the media, or change the media size setup. Remove obstructions. 2 Check the media tray pass through areas for obstructions. Are the pass through areas in all the media trays free from obstructions? Go to step 3. 2-146 Service Manual