Lexmark T652 Service Manual - Page 85
Lexmark T652 Manual
View all Lexmark T652 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
4062 Error code or message 243.08 Error contents Description/Action Possible repair actions Sensor (pass through) lingering jam Source = Tray 3 Media reached the sensor (pass through) within the specified time but did not clear it within the specified time. Go to sensor (pass through) lingering jam service check. See "Sensor (pass through) lingering jam service check." on page 2-146. Go to sensor (pass through) late jam service check. See "Sensor (pass through) late jam service check" on page 2-145. Go to sensor (pass through) static jam service check. See "Sensor (pass through) static jam service check" on page 2-147. Go to sensor (pass through) late jam service check. See "Sensor (pass through) late jam service check" on page 2-145. 1. Remove all media present in media path. 2. Close all media trays. Turn the machine off/on. 243.10 Sensor (pass through) late jam Source = Tray 3 The media is late reaching the sensor (pass through) within the specified time. 243.13 Sensor (pass through) static jam Source = Tray 3 Media remains on the sensor (input) during the warm up sequence. 243.16 Sensor (pass through) late jam Source = Tray 3 The media is late reaching the sensor (pass through) within the specified time. 243.17 Media tray pulled jam Source = Tray 3 A media tray above the source tray was pulled during the printing process. The engine timed out waiting for the tray 3 to report ready before the first pick attempt. The engine timed out waiting for the tray 3 to report ready before a pick retry attempt. Tray was not properly pushed into the machine. 243.18 Pick retry timeout Source = Tray 3 243.19 Pick retry timeout Source = Tray 3 Turn the machine off/on. 243.33 Tray 3 not ready Source = Tray 3 1. Check the size sensing fingers on the media tray for damage 2. Replace the media tray assembly if problem remains. 3. Check the switch (media size) for proper connection. 4. Replace the switch (media size) if problem remains. Go to "Switch (media size) assembly removal (T650, T652, T654)" on page 4-74. 1. Check the media out actuator for damage. 2. Replace the media out actuator if problem remains. Go to "Tray roller catch assembly removal (T650, T652, T654)" on page 4-81. 243.34 Empty tray pick attempted Source = Tray 3 The pick arm attempted to pick with no media in the tray. Diagnostic information 2-51