Lexmark T652 Service Manual - Page 223

4062-XXX 2. Reload RFID media in Tray 2 with the RFID media that was just printed in step 1, and then press continue. The test page will be printed. Note: The sheet should be placed face down with the arrow pointing toward the front of the printer. If the page looks like this: If the page looks like this: If the page looks like this: T65x RFID Option Test Step 1. Step 1 is complete. 1. Place this sheet in Tray 2 face-down with t arrow pointing toward the front of the printe 2. Press Continue. T65x RFID Option Test Step 1. Step 1 is complete. 1. Place this sheet in Tray 2 face-down with the arrow pointing toward the front of the printer 2. Press Continue. T65x RFID Option Test Step 2. Step two is complete. 1. Place a sheet of plain paper in Tray 2. 2. Press Continue. T65x RFID Option Test Step 2. Step two is complete. 1. Place a sheet of plain paper in Tray 2. T65x RFID Option Test Step 2. Step two is complete. 1. Place a sheet of plain paper in Tray 2. Then step 2 of the test passed. Proceed to step 3 Then the test has failed. This is an indication that the RFID tag could not be read. Possible causes: 1. Bad RFID media 2. RFID UHF option failure Try the test again with a new piece of RFID media. If the test fails again, replace the RFID UHF option. Then the test has failed. This is an indication that the RFID tag could not be read because the RFID sheet printed in step 1 was not reloaded (or reloaded incorrectly) for step 2. Try the test again with a new piece of RFID media and make sure the sheet printed in step 1 is reloaded into Tray 2 during step 2. Diagnostic aids 3-11