Lexmark T652 Service Manual - Page 233
Lexmark T652 Manual
View all Lexmark T652 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 233 highlights
4062-XXX • To change a digit or character, press • When the last digit is changed, press to increase or to decrease the value. to validate the Configuration ID 1. If Invalid ID appears, the entry is discarded, and the previous Configuration ID 1 is displayed on the screen. If the process is successful, Submitting Selection appears on the display, followed by the current value for Confirguration ID 2. 4. Repeat the steps for entering the Configuration ID, and press . appears next to If the Configuration ID 2 is validated, Submitting Selection appears, and a check Printer Setup. 5. Restart the printer. Edge to Edge When this setting is On, the text and graphics are shifted to the physical edges of the paper for all margins. When the setting is Off, the normal margins are restored. EP SETUP EP Defaults This setting is used to restore each printer setting listed in EP SETUP to its factory default value. Sometimes this is used to help correct print quality problems. To restore EP Defaults: 1. Select EP Defaults from EP SETUP. 2. Select Restore to reset the values to the factory settings, and select Do Not Restore to exit without changing the settings. Fuser Temperature (Fuser Temp) This adjustment can be used to help solve some customer problems with paper curl on low grade papers and problems with letterheads on some types of media. The fuser temperature can be adjusted to: Normal, Lower, Lowest. The default is Normal. Fuser Page Count The fuser page count can only be viewed and cannot be changed. To view the Fuser Page Count: 1. Select Fuser Page Count from EP SETUP. 2. Press Back to return to PRINTER SETUP. Warm Up Time You can change the amount of time the printer warms up before allowing pages to print by changing this setting from 0 to 5. The factory sets the warm up at 0 or no warm up time. This time period lets the backup roll heat up and helps reduce curl in some environments. Transfer The transfer can be adjusted to Low, Medium, or High. The default setting is Medium. Diagnostic aids 3-21