Lexmark T652 Service Manual - Page 232

4062-XXX The page count can only be viewed and cannot be changed. To view the page count: 1. Select Page Count from PRINTER SETUP. 2. Press Back to return to PRINTER SETUP. Perm Page Count (permanent page count) The permanent page count can only be viewed and cannot be changed. To view the permanent page count: 1. Select Perm Page Count from PRINTER SETUP. 2. Press Back to return to PRINTER SETUP. Serial Number The serial number can only be viewed and cannot be changed. To view the serial number: 1. Select Serial number from PRINTER SETUP. 2. Press Back to return to PRINTER SETUP. Engine Setting 1 through 16 WARNING: Do not change these settings unless requested to do so by your next level of support. Model Name The model name can only be viewed and cannot be changed. Configuration ID The two configuration IDs are used to communicate information about certain areas of the printer that cannot be determined using hardware sensors. The configuration IDs are originally set at the factory when the printer is manufactured, however the servicer may need to reset Configuration ID 1 or Configuration ID 2 whenever you replace the system board. The IDs consist of eight hexadecimal characters, including 0 through 9 and A through F. Note: When the printer detects a Configuration ID that is not defined or invalid, the following occurs: • The default standard model Configuration ID is used instead. • Configuration ID is the only function available in DIAGNOSTICS. • Unless the menu is in DIAGNOSTICS, Check Config ID displays. To set the configuration ID: 1. Select Printer Setup from the Diagnostic mode. 2. Select Configuration ID from the Printer Setup menu. Submitting Selection displays, followed by the value for Configuration ID 1. 3. Enter the Configuration ID 1. • To select a digit or character to change, press or until the digit or character is underlined. 3-20 Service Manual