Lexmark T652 Service Manual - Page 39

4062 Error code or message 37 Error contents Description/Action Possible repair actions Insufficient Memory This message displays when the printer memory used to restore the Print and Hold jobs from the disk and found that some or all of the jobs could not be restored. The printer ran out of memory while attempting to restore the jobs. The following actions may be taken: • Press to clear the message. Some of the Print and Hold jobs on the disk will not be restored. They remain on the disk, but cannot be accessed. • Press until Busy/ Waiting appears. The following functions may be available: - Cancel Job - Reset Printer Reset Active Bin 38 Memory Full This message displays when the printer is processing an incoming job and there is insufficient memory available to continue processing the job. The following actions may be taken: • Press to clear the message. Perform the defragment operation: - Perform the defragment operation - Delete fonts, macros, and other data in RAM - Install additional memory • Press to display Busy/ Waiting. The following functions may be available: - Cancel Job - Reset Printer Reset Active Bin 39 Complex Page This message displays when the page is too complex to print. The following actions may be taken: The following actions may be taken: • Press to clear the message and continue the job. Some data loss may occur. Simplify the print job and reprint, if necessary. • Press until Busy/ Waiting appears. The following selections are possible: - Cancel Job - Reset Printer Reset Active Bin Diagnostic information 2-5