Lexmark T652 Service Manual - Page 50

4062 Error code or message 200.13 Error contents Description/Action Possible repair actions Sensor (input) static jam Media remains on the sensor (input) during the warm up sequence. Go to sensor (input) static jam service check. See "Sensor (input) static jam service check" on page 2-135. Go to sensor (input) early jam service check. See "Sensor (input) early jam service check" on page 2-133. 1. Remove all media present in media path. 2. Check all connections on the printhead. 3. Check all connections on the system card assembly. 4. Replace the printhead if problem remains. Go to "Printhead assembly removal (T650)" on page 4-60 or "Printhead assembly removal (T652, T654)" on page 4-61 5. Replace the system card if problem remains. Go to "System card assembly removal (T650, T652, T654, T656)" on page 4-76. 1. Remove all media present in media path. 2. Check all connections on the main drive motor assembly. 3. Check all connections on the system card assembly. 4. Replace the main drive motor assembly if problem remains. Go to "Output cover assembly removal (T650, T652, T654)" on page 4-54. Go to sensor (input) lingering jam service check. See "Sensor (input) lingering jam service check." on page 2-132. Go to sensor (input) lingering jam service check. See "Sensor (input) lingering jam service check." on page 2-132. 200.14 Sensor (input) early jam The media reached the sensor (input) sooner than the specified time. 200.15 Laser power did not settle Laser circuit failure on printhead or system card assembly. 200.16 Main drive motor assembly load error The main drive motor assembly has failed or caused high mechanical load due to paper jam or bind. 200.17 Sensor (input) lingering jam Source = Tray 1 Tray level= Not Low The media reached the sensor (input) but did not clear it within the specified time. 200.18 Sensor (input) lingering jam Source = Tray 1 Tray level = Low The media reached the sensor (input) but did not clear it within the specified time. 2-16 Service Manual