Lexmark T652 Service Manual - Page 183

4062 Step Check Perform a print test using the output option. Does the error continue? Yes Replace the output option. No Problem solved. 5 Sensor (stapler pass through) lingering jam service check Step 1 Check Check the output option for proper installation. Is the above component properly installed? Yes Go to step 2. No Remove then reinstall the output option Remove obstructions. Go to step 4. 2 Check for obstructions in the media path between the Sensor (stapler pass through) machine and the media bin. Is the media path free from obstructions? Check the sensor (stapler pass through) for proper operation. 1. Enter the diagnostic mode 2. Select Finisher sensor test 3. Select Sensor test 4. Select pass & media 5. Observe the line item "passthru" Does the display on the operator panel, change every time the sensing area of the above sensor is interrupted or blocked. Go to step 3. 3 Go to step 5. 4 Check the above sensor for proper connection. Is the above sensor connected properly? Replace the stapler unit assembly. Go to "SFP stapler assembly stapler unit assembly removal" on page 4-182. Replace the connection. 5 Perform a print test using the output option. Does the error continue? Replace the output option. Problem solved. Sensor (stapler pass through) static jam service check Step 1 Check Check the media path for partially fed or jammed media. Is the media path free from partially fed or jammed media? Yes Go to step 2. No Remove any prestaged or jammed media. Diagnostic information 2-149